Raychem 10VPL2-CT - VPL at 230V - Power Limiting Trace Heating Cable
nVent RAYCHEM VPL is a family of power limiting heating cables designed for pipe and equipment heat-tracing in industrial applications.
VPL can be used for frost protection and process temperature maintenance requiring high power output and/or high temperature exposure. VPL can provide process temperature maintenance up to 235°C (depending on cable type) and can withstand routine steam purges and temperature exposure to 260°C with power off.
Power-limiting cables are parallel heaters formed by a coiled resistor alloy heating element wrapped around
two parallel conductors. The distance between conductor contact points forms the heating zone length. This parallel construction allows it to be cut-to-length and terminated on-site. The power output of VPL heating cables decreases with increasing temperature. VPL heating cables can be overlapped once. The relatively Ã¯Â¬Âat power temperature curve of VPL ensures a low start-up current and high output at elevated temperatures. VPL cables are approved for use in hazardous areas. Approvals are listed below.
- Hazardous, Zone 1, Zone 2 (Gas), Zone 21, Zone 22 (Dust)
Traced Surface Type:
- Carbon steel
- Stainless steel
- Painted or unpainted metal
- Organics and corrosives
- For aggressive organics and corrosives consult your local Pentair representative
The VPL heating cables are approved for use in hazardous areas by Baseefa Ltd.
- Baseefa06ATEX0188X & IECExBAS06.0048X
- II 2GD & Exe II T* (see schedule) Ex tD A21 IP66
- Ex e II T* (see schedule) Ex tD A21 IP66Ã¢ÂÂ
*By design. Temperature classiÃ¯Â¬Âcation (T-rating) has to be established by using the principles of stabilized design or the use of a temperature limiting device. Use TraceCalc design software or contact Pentair.
Maximum Circuit Length
Based on type 'C' circuit breakers according to EN 60898
|Electrical Protection Sizing||Start Up Temperature||Maximum Heating Cable length per circuit(M)|
*The maximum heating cable length must not exceed these values, even when voltage adjustment factors are used.
The above numbers are for circuit length estimation only. For more detailed information please use the Pentair TraceCalc software or contact your local Pentair representative.
Pentair requires the use of a 30 mA residual current device to provide maximum safety and protection from Ã¯Â¬Âre.
Where design results in higher leakage current, the preferred trip level for adjustable devices is 30 mA above any inherent capacitive leakage characteristic of the heater as speciÃ¯Â¬Âed by the trace heater supplier or alternatively, the next common available trip level for non adjustable devices, with a maximum of 300 mA. All safety aspects need to be proven.
|Cable||208 V||230 V||254 V||277 V||400 V||480 V|
|Maximum maintain or continuous exposure temperature (power off)||5VPL2-CT||235°c||230°c||225°c||225°c||-||-|
|Maximum intermittent exposure temperature (power off)||260 °C|
|Minimum bend radius||At -60°C: 20 mm|
|Minimum installation temperature||-60 °C|
|Temperature classification||To be established using the principles of stabilized design or the use of a temperature limiting device.|
|Voltage||VPL2 at 230 V|